Grip Hole

Well, it's new grip time.

If anyone is wondering how to get that nice round hole in the grip-end that is needed for the handguard mount, the answer is a step drill bit. At least that's how I do it.

In this case, bar had a 7/8" control area with, so I drilled the grip end from the center out to the total 7/8". A fat bar adaption would, of course, require a 1-1/2" hole. 

Avoid rubber overlap that may interfere with a tight contact between the handguard frame/expansion anchor bolt to the bar end. Use an Exacto knife to trim overlap and excess, if necessary.

Viola!